- Body
- Rear bumper has been fitted. Overall pretty easy because they mount it on the body for shipping so some of the work is already done. I did trim around the trans mount because the build manual just showed it going over the studs and I did not like that. Easy to dremel around so it sits flush.
- Side panels riveted on the underside of the car to free up some of my clecos.
- Electrical
- iWire sent me the terminal lead to the ECU for AC. I spliced it into my compressor wire.
- My engine died when running it yet again due to electrical issues. Looks like those 3 wires were somehow not my issue or at least weren’t the only issue. The car started working again after wiggling the fuesbox wires so I think a ground or some other terminal connection on the backside of the fusebox is loose. I will take them off soon and investigate the issue.
- I am replacing one of the cam position sensors that keeps filling itself with oil for some reason. I cleaned this once before but it must have some type of internal leak so it had oil in it again.
Clearanced trans mount studs
Everything fixed to the chassis
Looks good!
The faulty sensor
How I earn garage rent: replacing parent’s brakes
ECU A/C wire spliced into the compressor wire
Somewhere in here are the electrical gremlins
